Skip to content
You Are Here

Category: Classical

8 thoughts on “ Noise Gate - Doktor Loop - Loop Is Life E.P. (Vinyl)

  1. Dec 29,  · the reason you cant use a noise gate in a parallel effects loop, is that all the noise from the preamp, not only goes throught the effects loop (and thus the noise gate) but also through the direct line, thereby bypassing the noise gate, and running into your power amp anyways. in a serial fx loop, the direct line is cut when the loop is.
  2. Vehicular Loop Detector Systems Loop detectors and loops are strongly recommended on all automated vehicular gate applications to help prevent gates from closing on vehicles in the path of the gate. Single and dual channel circuit boards available. Easy to install plug-in detectors (DKS Gate Operators only), and hard-wired detectors available. \u\uPre-fabricated loops available, or.
  3. Jan 22,  · A viewer sent in a question about where a noise gate pedal should go in the signal chain. In this video, Dave talks about where it's best to put one of these devices in your signal path. Review of.
  4. The size of the loop also determines the loop placement. The larger the loop, the greater the spacing must be between the loop and the gate. Essentially, loops should be placed a minimum of 4’ from the gate. When connecting more than one loop to a detector, always connect the loops in series.
  5. Sep 11,  · And keeping "decay" effects (delay, reverb etc) after the gate makes sense too. But if you use pedal distortion, running the amp mainly clean, you might not gain anything from sticking a gate in the fx loop. As long as you get the gate in as close as possible after the noise source (i.e. right after the noisy distortion pedal), you should be fine.
  6. May 27,  · Not only is it as inexpensive but it features a noise gate and an effects loop, all with superior EHX circuitry. This circuitry includes three knobs: Release, Threshold, and Reduction. Unlike others here, which largely just let you control the threshold, this one lets you choose exactly how much noise reduction you want.
  7. Apr 24,  · I am thinking of using a noise gate to try and tame the noise level of my two fuzz pedals in the ES Can anyone confirm the following (I don't have a noise gate yet). (1) if I put the noise gate in the volume loop, and then make sure I program a patch so that it follows after fuzz in the loop structure, will that solve the issue?
  8. Sep 06,  · Re: Suggestions for loop Noise Gate Sun, Jun 19, pm It has been about 10 years since I owned an MXR Smart Gate, but I remember it made my amp sound like it was covered with a blanket when the Smart Gate was turned on.

Leave a Reply

Your email address will not be published. Required fields are marked *